I-Series Flip Terminal Setup Guide

Congratulations on receiving your new equipment. This Quick Start Guide will assist you with self-installing the Elo I-Series Flip Terminal and registering the device with your account.

Article Contents

• Before You Start
• Hardware Setup
  • Step 1: Set Up the Stand
  • Step 2: Mount the Display
  • Step 3: Connect the Cables
  • Step 4: Power On Equipment

Before You Start

Before setting up your new equipment, ensure that your site meets the Network and Infrastructure Requirements. You will need a power source conveniently located near the desired location, plus a fast and reliable Internet connection. For additional information, contact your Account Specialist.

Hardware Setup

Step 1: Set Up the Flip Stand & Display

The instructions below outline how to setup the flip stand (not the tabletop stand). 

1. Rotate the display mount and remove the four screws and cover plate from the stand.
2. Run the cables through the hole in the base of the stand as shown and secure them to the cord hooks with a cable tie (optional but recommended).
3. Reattach the cover plate and secure it with the four screws.

Step 2: Mount the Display

1. Remove the cover plates on the back of the display by lifting them upward. Note: the packet of screws under the cover will secure the plates back on.
2. Mount the display to the flip stand using the screws provided.

Step 3: Connect the Cables

1. With the display securely mounted, connect the ethernet cable to the ethernet port (if using a hardwired connection).
2. Connect the power cable to the port on the back of the device. Note: Do not plug the power cord into the wall outlet, as the device should remain off.
3. Connect the printer’s USB cord to the USB port in the other port bay.
4. Secure the cables to the cord hooks with a tie-wrap (encouraged).
5. Reattach the cover plates. Use the screws provided to secure the cover plates to the back of the display.
6. Then, connect the cable to the ethernet port on your router.

Step 4: Power On Equipment

1. Plug the power cord from the display into a properly grounded AC outlet. Note that the device will automatically power on once connected.
2. If connected to the Internet via an ethernet cable, the Setup Wizard will automatically appear moments after the device powers up.
3. To connect via Wi-Fi:
   1. Press and hold the power button (left) and simultaneously press the home button (right) to enter the Elo control panel.
   2. Enter "1elo" as the password to access the control panel's home screen.
   3. From the home screen, tap Networks and connect to your wireless network. After establishing an Internet connection, the device will automatically reboot, and the Setup Wizard will appear on the screen.