Congratulations on receiving your new equipment. This quick start guide will assist you with self-installing the Elo PayPoint Plus all-in-one terminal and registering the device with your account.
Article Contents
- Before You Start
-
Hardware Setup
- Step 1: Connect Power and Internet
- Step 2: Install Receipt Paper
- Step 3: Power on the Device
Before You Start
Before setting up your new equipment, ensure that your site meets the Network and Infrastructure Requirements. You will need a power source conveniently located near the desired location, plus a fast and reliable Internet connection. For additional information, contact your Account Specialist.
Hardware Setup
Setting up the PayPoint Plus all-in-one solution is a breeze.
Step 1: Connect Power & Internet
The connections are located underneath the register. If using a LAN connection, plug the ethernet cable into the ethernet port (A). Next, plug the supplied power cord into the power connector (B) and the device into a power outlet.
Step 2: Install Receipt Paper
Flip the display head away from the receipt printer (in the customer-facing view). Pull the receipt printer release lever (C) to open the printer lid and install the supplied receipt printer.
Please note the correct paper orientation from the picture below.
Step 3: Power on the Device
Press the power button (D) on the display head's back. If connected by LAN, the registration will start automatically.
If using Wi-Fi:
- Press and hold the power button (left) and simultaneously press the home button (right) to enter the Elo control panel.
- Enter "1elo" as the password to access the control panel's home screen.
- From the home screen, tap Networks and connect to your wireless network. After establishing an Internet connection, the device will automatically reboot, and the Setup Wizard will appear on the screen.